FOCAL - Forward Calorimeter: Difference between revisions
No edit summary |
No edit summary |
||
| (7 intermediate revisions by 3 users not shown) | |||
| Line 6: | Line 6: | ||
== Mimosa chips == | == Mimosa chips == | ||
* [[Media:PH1-UserMan-20080916.pdf|preliminary user manual of Phase1]] | * [[Media:PH1-UserMan-20080916.pdf|preliminary user manual of Phase1]] | ||
* [[Media:mimosa.bsd.txt|BSDL file of Phase1]], which can be used for JTAG test, such as an XJTAG module. | * [[Media:mimosa.bsd.txt|BSDL file of Phase1]], which can be used for JTAG test, such as with an XJTAG module. | ||
* [[Media:pattern_test.svf.txt|SVF file for pattern-only mode test of Phase1]], Use XJTAG to configure Phase1 chip with it, LVDS data output signals will appear on the 4 channels after supplying 160MHz differential clock and START signal. | * [[Media:pattern_test.svf.txt|SVF file for pattern-only mode test of Phase1]], Use XJTAG to configure Phase1 chip with it, LVDS data output signals will appear on the 4 channels after supplying 160MHz differential clock and START signal. | ||
| Line 26: | Line 26: | ||
==== Software ==== | ==== Software ==== | ||
* [[Setting Up PetaLinux System]] | |||
Petalinux documentation: | * Petalinux documentation: [http://www.petalogix.com/resources/documentation/petalinux_sdk petalinux_sdk] | ||
[http://www.petalogix.com/resources/documentation/petalinux_sdk] | |||
* [[Get readout box up and running]] | |||
* [[Programming Mimosa chips]] | |||
==Readout software== | |||
[[Report by Tony]] | |||
[[Category:Mikroelektronikk]] | |||
Latest revision as of 14:47, 10 August 2012
This page should contain information about the Focal project, especially about the interfacing from the Mimosa chips to the readout electronics.
Overview
Simple description of the Alice Focal readout electronics.
Mimosa chips
- preliminary user manual of Phase1
- BSDL file of Phase1, which can be used for JTAG test, such as with an XJTAG module.
- SVF file for pattern-only mode test of Phase1, Use XJTAG to configure Phase1 chip with it, LVDS data output signals will appear on the 4 channels after supplying 160MHz differential clock and START signal.
Readout electronics
Adapterboard /Fanoutboard
The adapterboard and fan-out boards provide LVDS interfaces and JTAG interfaces between the Control and Read-out board and the Mimosa ASICs. Here is the schematics of the boards.
- Spartan6 FPGA type: XC6SLX150-FGG676, speed-grade: 3
- Examples of user constraint files for Spartan6 FPGAs: U1 , U2
- EXamples of VHDL entity definations for Spartan6 FPGAs: U1 , U2
Control and Readout board
The idea is to use a Xilinx Virtex 6 development board as a first prototype. The board will run Petalinux, and some software to access the firmware registers. A software framework for the TPC detector is to be adapted for the use on the Virtex 6 board and Petalinux.
Firmware
The VHDL counterpart is to be found here: http://web.ift.uib.no/kjekscgi-bin/viewcvs.cgi/alice-fw/trunk/messagebuffer/
Software
- Petalinux documentation: petalinux_sdk