View source for XJTAG for new prototypes

To make an automated test setup for a new prototype pcb, a few things are needed.

* Cable from XJlink to fit the prototype board. From 2x10 pin ribbon cable connector to TAP connection on the PCB. Pins 1,2,4 & 20 are reserved for VCC, NC, GND & GND on the XJlink. The rest is configurable. 

* Netslist of the prototype circuit, for fast setup of XJDeveloper. This can be omitted, but having a netlist will make things faster and easier. 

* BSDL file for the JTAG equipped IC's on the pcb. This is needed to set up the JTAG chain for the XJDeveloper. 

* XJTAG also provides a .h file for interfacing drivers with C 

links to api:
[http://www.xjtag.com/XJAPI.h XJAPI.h]
[http://www.xjtag.com/jtag-tools/xjapi-jtag-access.php XJAPI docs]

[[Category:Mikroelektronikk]]
[[Category:Programming]]
[[Category:JTAG]]
[[Category:XJTAG]]